![]() and 20: Allen Datagraph 230/315 Vinyl Cutte.and 18: Allen Datagraph 230/315 Vinyl Cutte.and 16: Allen Datagraph 230/315 Vinyl Cutte.and 14: Allen Datagraph 230/315 Vinyl Cutte.and 12: Allen Datagraph 230/315 Vinyl Cutte.and 10: Allen Datagraph 230/315 Vinyl Cutte.and 8: Allen Datagraph 230/315 Vinyl Cutte.and 6: Allen Datagraph 230/315 Vinyl Cutte.and 4: Allen Datagraph 230/315 Vinyl Cutte.and 2: MODEL 230 FRICTION FEED Allen Datag.Bearings for the belt drive and gritwheel shaft should be lubricated with light oil every 6 months of heavy use. LUBRICATION Most mechanical parts on the 230/315 will not need lubrication and since oil and grease can attract dirt, unnecessary lubrication should be avoided. CAUTION: Do not use any abrasive cleaners as they will cause the paint to blister. This solution works well on all painted surfaces. It is suggested that a mild soap and water be used with a soft cloth. If necessary, a mild cleaning solution on a damp cloth can be used to gently wipe the surfaces clean. The outer surfaces should also be kept clean. Clean the set of polyurethane pinch wheels by using a soft cloth and rubbing alcohol. Keeping the grit wheel clean is important so the plotter will hold the media accurately. CAUTION: Be sure to disconnect the plotter from the power source while cleaning the unit. Brush the surface of the grit wheel while turning the grit wheel by hand so the entire surface of the grit wheel is cleaned. Clean the grit wheel surface with a soft bristled brush to remove any media particles that may have built up during plotting. It is recommended that the following cleaning steps be done at least as often as indicated for each procedure. 42Īllen Datagraph 230/315 Vinyl Cutter SERVICE CLEANING The regularity with which the plotter needs to be cleaned is dependent on the usage, as well as the climate and contaminants in the plotter’s environment. Stripes and designs with long back and forth movement on large material can slip at standard acceleration. Reduce acceleration and, if necessary, speed. For punched (sprocket) material, refer to item above. Clean gritwheel with a soft bristle brush (toothbrush) if the grit is "clogged" with paper particles at the pinch wheel points. Clean pinch wheels with denatured alcohol and a soft cloth. Material slippage Image elements are shifted in the X axis (material direction). Verify that the edge guide discs are set no more than 1/16th inch (1 to 2 mm) wider than material. Verify that the fixed edge guide discs are at an equal distance from the machine side plate. Verify that the edge guide discs are set no more than 1/16th inch (1 to 2 mm) wider than the material. Verify that edges of material are straight and not damaged. Material bunches on long tracking guides. Not straight with tracking guide bars installed. See Pinch Wheel Maintenance in this book. Small mold gates should be towards outside. Inspect pinch wheel orientation for newly installed pinch wheels. ![]() ![]() Clean gritwheel with soft bristle brush (toothbrush) as necessary. Verify with confidence test (diagnostic 2). This will require repositioning the right hand pinch wheel. Move pinch wheels to unpunched area of material on both left and right side. Not straight with tracking guide bars removed. Allen Datagraph 230/315 Vinyl Cutter Material Handling Troubleshooting PROBLEM SYMPTOM REMEDY Material does not track straight Material is punched.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |